From refreshing houseplants to maximising yields and potential in commercial hydroponics. FlashClean is one of the strongest tools available to gardeners!
Eventually, every growing system will get fertilizer build up as a natural part of the growing process. This build up results in salt build up that can block drippers. Causes dirt on the top of soil or substrate, and eventually cause undue stress and even root damage.
With the highly concentrated nutrients today, and high EC levels in many systems, nutrient lockout can also be an invisible limit on your grow. FlashClean solves all these problems and more:
Dissolves built up fertiliser salts
Corrects nutrient balance
Treats nutrient lock out
Feeds microbial life and refreshes soil and coco coir
Improves final stage growth (especially with FinalPart)
Specifically developed to dissolve salts, it releases nutrient bonds between minerals and substrate and allows you to rinse excess salt. This release also helps plants make the most of food, especially in the crucial week before harvest.
Unlike other “flushes” and finishers on the market, FlashClean is not an acid, isn’t enzyme based, and does not dump magnesium or other minerals into your system, this makes it uniquely flexible. With FlashClean you can give your system, and your plants, a clean slate at any time and at any stage of the growth process.
No matter what type of growing system you’re using
Indoors or outdoors, soilless or hydro, pots or garden beds, FlashClean is easy to use. Just mix with pH water and apply.
Check additional info for dosage advice
Check out TA!
To reset and refresh before changing nutrients (inc. before FinalPart®) : add 1.5 to 3 ml/L of FlashClean® to your existing nutrient solution and circulate for 24 hours before draining and replacing with fresh nutrient solution. Use the lower dosage for young or fragile plants, and the higher dosage for established plants / close to harvest.
After nutrient burn or lock-out : drain old nutrient solution, add 1.5 to 3 ml/L of FlashClean® to pH adjusted water (you don’t need to use a full tank, just enough to circulate freely and run the system). Circulate for 24 hours before draining and adding new, fresh nutrient solution. Use the lower dosage for young or fragile plants, and the higher dosage for established plants.
As a final rinse (after FinalPart®) : drain old nutrient solution, add 1.5 to 3 ml/L of FlashClean® to pH adjusted water (you don’t need to use a full tank, just enough to circulate freely and run the system). Circulate for the last two days before harvest to increase sugar levels in your crop instead of losing aroma and medicinal content with a long water flush.
To reset and refresh before changing nutrients (inc. before FinalPart®), and after nutrient burn or lock-out : every fifteen days (or when needed after lock out etc), fill a watering can with fresh pH adjusted water and add 1.5 to 3 ml/L of FlashClean®. Drench until there is runoff from the bottom of the pot. Resume your regular fertiliser schedule with the next watering. Use the lower dosage for young or fragile plants, and the higher dosage for established plants.
As a final rinse / after FinalPart® : use 3 ml/L of FlashClean® instead of nutrients during the last two days before harvest to increase the sugars level in your crop instead of losing aroma and medicinal content with a long water flush.
NB : FlashClean® can be used at any stage of growth or flowering but do not use FlashClean® more than once every two weeks.
